Menvier Security SD1 User Manual download pdf (Page 10)

10. Viewing The Last Call Log

When a call is successfully acknowledged the SD1 stores the event in a "Last Call Log".

The log may then be viewed as follows:

Ensure that the SD1 is initialised and the

display is showing "READY".

The display will show the Last Call Log e.g.,

"SENT A to [-2-]" (Alarm on trigger input A

acknowledged by recipient 2). If the display

shows [---] then none of the calls was

acknowledged.

Press the ] key to return to "READY"

11. Cancelling an Activation.

Occasionally you may trigger your alarm by accident and cause the SD1 to send an

unwanted call. When this happens the unit cannot be stopped by pressing the ] key or any

of the other keys. Control of the SD1 is disabled until the call has been successfully

acknowledged or until the unit has cleared down after the final attempt.

However there are two actions you may try to ensure that the alarm is intercepted:

1. If a telephone is connected on the same line as the SD1 you may lift the handset

and talk over the top of the SD1 message. Advise the recipient of the call not to

respond to the alarm.

2. If a telephone is connected on the same line as the SD1 you may use it to

acknowledge the SD1 yourself (providing it is a tone type telephone).

Page 8

SD1 Operating Instructions

ENTER 1-3 OR 0-C

SENT A TO [-2-]

Press the [ key

Press the ] key

READY

Press the [ key

1 2 ... 5 6 7 8 9 10 11 12

No comments

Menvier Security SD1 User Manual Page 10