Menvier Security TS400 User Manual download pdf (Page 18)

Programming Telephone Numbers

The TSD402 can store up to three telephone numbers with a maximum of 16 digits for each.

Before storing any telephone numbers, the permission of the persons being called must be

obtained. The `Emergency Services' telephone number (999 &112) cannot be stored.

WhentheTSD402dialsatelephonenumberitwillautomaticallyselectthecorrectdiallingformat.

Currently in the U.K. there are two formats:

Pulse Dialling - This is the older format and is sometimes referred to as Loop

Disconnect (LD).

Tone Dialling - This is the modern format and is sometimes referred to as Multiple

Frequency (MF).

Any or all of the telephone numbers can be selected to override the automatic format selection

and be forced into dialling the number in one of the above formats, if required.

If the TSD402 is connected to an internal PABX telephone exchange system, normally the

exchange requires a pre-fixed digit to be dialled before obtaining an outside line (normally 9).

Some exchanges also require a pause after the pre-fixed digit before dialling the telephone

number.Whenenteringtelephonenumbersitispossibletoinserta3secondpause,ifrequired.

The functionality of the

[

key changes when programming telephone numbers, as follows:

Erase number

- A short press of the

[

key when the current number is displayed will

clear the display.

Accept number

- Press the

[

key for 3 seconds to enter the number shown on the

display into the non-volatile memory.

Tone Dialling

- A short press of the

[

key when the display is blank will cause a `T'

to be displayed, indicating `Tone dialling' is selected. Proceed by

enteringthedigitsofthetelephonenumberyourequireto`ToneDial'.

Pulse Dialling - Twoshort pressesof the[keywhenthedisplayisblankwillcausea `P'

to be displayed, indicating `Pulse dialling' is selected. Proceed by

entering the digits of the telephone number you require to `Pulse

Dial'.

Inserting a Pause - Ashortpressofthe[keyafteranydigithasbeenenteredwillcauseaP

to be displayed, indicating a pause has been inserted. Proceed by

entering the remaining digits of the telephone number.

User Options TSD402 User Manual

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 31 32

Comments to this Manuals

No comments

Menvier Security TS400 User Manual Page 18

Comments to this Manuals

Related products and manuals for Security access control systems Menvier Security TS400