Menvier Security SD1 User Manual

SD1SPEECH DIALLEROPERATINGINSTRUCTIONSB CAENT0ESC7 8 95 641 2 3SD1

10. Viewing The Last Call LogWhen a call is successfully acknowledged the SD1 stores the event in a "Last Call Log".The log may then be view

12. Trouble-Shooting GuideProblem The unit will not dial the telephone number that I have programmed.Cause Number incorrectly dialledAction Check the

If the unit is not operated for 1 minute, it will revert toits normal standby mode and the display will showNOTE: When the unit is first switched on t

CONTENTSSection Title Page1 Overview. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 12 Initialising th

1. OverviewConnections: The SD1 is connected between the alarm control panel and the telephoneline. It behaves like another extension to the telephone

2. Initialising the SD1When the SD1 is switched on the display will show "PLEASE RE-RECORD" and the unit will beepevery 30 seconds. This ind

Programming Telephone Numbers (Cont.)When the SD1 dials a telephone number it will automatically select the correct diallingformat. In the U.K. there

5. Replaying MessagesOnce the phrases have been recorded it is possible to play them back through the built inloudspeaker.The following example shows

7. Sending A Test CallIt is possible to test that each message plays to each of the telephone numbers. e.g., youmay want to test that "Message A&

8. Test ActivationWhen the unit is triggered on one of the inputs A, B or C the display will show "-ON-" throughoutthe procedure. This test

9. Changing the Acknowledgement OptionThe SD1 acknowledgement can be set to one of the following options:CLEARED BY ANY 1: The SD1 will clear down whe