Menvier Security TS700 Specifications download pdf (Page 60)

Commercial Part-Set Application

This application example shows how to use the

"Code Set Groups" to set and unset different areas

within a commercial premises. Using the drawing

of the building the following is required:

The Sales Manager requires independent

access to the Sales department and the

Canteen.

The Workshop Manager requires independent

access to the Workshop area and the

Canteen.

The Stores Manager requires independent

access to the Stores area and the Canteen.

The Service Manager requires independent

access to the Service department.

1. From the above requirements assign each

area to a ward, e.g.:

Ward A: Sales department and Canteen.

Ward B: Workshop and Canteen.

Ward C: Stores and Canteen.

System Ward: Service department.

2. Using the above ward requirements create a

Table for assigning circuits to wards. Circuits

withnoticksareassignedto the“SystemWard”:

Circuit Location Ward A Ward B Ward C

01 Sales Entrance Door 4

02 Sales PIR 4

03 Workshop PIR (1) 4

04 Workshop Entrance 4

05 Workshop PIR (2) 4

06 Workshop door 4

07 Workshop PIR (3) 4

08 Sales Internal Door 4

09 Canteen Door 4 4 4

10 Canteen PIR 4 4 4

11 Stores Entrance 4

12 Stores PIR 4

13 Stores Internal Door 4

14 Sales (Office PIR) 4

15 Service Entrance

16 Service PIR

+

The canteen door and PIR are assigned

to wards A, B and C, this will ensure that

they are only armed when all three

wards are set. This allows access to the

canteen when any of the wards A, B or C

are unset.

3. From the Table assign circuits 01-16 to their

relevant wards (see “Configure Wards” on

page 37).

4. Program the code set groups (see “Code set

Groups”, on page 43).This ensures that when

theuserenterstheirpasscode thecorrectward

set or unsets. For this application example the

code set groups are programmed as follows:

Full Set Group: [S ]

Code Set Group A: [ A ]

Code Set Group B: [ B ]

Code Set Group C: [ C]

5. Assign each “Code Set Group” with a

passcode. For full details of programming the

user passcodes refer to the User Manual.

Key Point Application Example

This application example shows how to use the

“Key Point” circuit to fully set and part-set the

system using a three position keyswitch. The

Keyswitch is mounted in an electrical blanking

plate together with an LED to indicate circuit faults

when setting and part-setting the system.

Zx

Panel output 2

Full Set Part Set

Unset

1K resistor LED

AUX +12V

3 Position keyswitch

e.g., Farnell 140-533

Circuit x

Tx

Figure 29 Key Point Wiring Details

Appendices TS790 & TS900 Installation Manual

56

1 2 ... 55 56 57 58 59 60 61 62 63 64 65 66 67 68

Comments to this Manuals

No comments