Menvier Security SD1 User Manual download pdf (Page 14)

Recording Messages

The SD1+ can record up to four phrases A, B, C, D and a common phrase 0. These phrases can be

up to forty seconds in total. The five phrases are used to form four messages A, B, C and D. Phrase 0

is normally used to store the name and address of the premises, whereas phrases A, B, C or D are

used to store the type of alarm condition. It is also advisable to include the instruction to press the

number "8" button on the telephone, at the end of the message e.g.

Phrase 0: “This Is Mr Smith, at 10 The Strand, East Fincham”

Phrase A: “The alarm has been activated, please press eight to acknowledge this call”.

Ensure that the SD1+ is initialised and the display is showing

“

” (see page 4).

Press [ and the unit will display “ ”.

Press 0 for phrase 0.

0 to D will select phrases 0, A, B, C or D.

1 to 4 selects numbers 1, 2, 3 or 4 (see pages 8-11).

The display will show “ ”.

Stand back about 6-8 inches from the unit.

Before you record phrases, it is advisable to prepare

them by writing them down first.

When ready, press the [ key to start recording, and speak

clearly into the unit.

The display will show the remaining recording time.

When re-recording a phrase, if the duration of the old

phrase was previously 10 seconds, then the new phrase

must be the same length.

To end recording at any time press .

The unit will also stop recording when the time runs out.

Repeat for phrases A, B, C & D as required.

When finished, press ] to return to the ready prompt.

OR 0-D

[

RECORD

PHRASE 0

[

REC - 40

REC - 32

ENT 1-4

OR 0-D

READY

]

READY

SD1+

????

ENT 1-4

This is Mr Smith,

at 10 The Strand,

East Fincham.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 20

Comments to this Manuals

No comments

Menvier Security SD1 User Manual Page 14

Comments to this Manuals

Related products and manuals for Door intercom systems Menvier Security SD1