Menvier Security SD1 User Manual download pdf (Page 16)

Testing the SD1+: Call Acknowledgement Procedure

If the unit has been triggered or a test call has been sent, you must

ensure that the recipient of the call is aware of the call

acknowledgement procedure, so that they can successfully shut

down the SD1+ and prevent it from dialling them again.

When the recipient's telephone rings, they should answer the

call as they would any normal call.

The SD1+ will then play the message that corresponds to the

trigger it has received, (normally the name and address of the

premises followed by the relevant alarm message).

After the message, a tone is heard, the recipient should now

press the “8” button on the telephone to acknowledge the call.

Pressing the number “8” button on the telephone at any

point during the message, will also shut the unit down.

If done correctly, an acknowledgement “tune” will be heard.

The recipient can then take the necessary action.

Playing Back Messages

Once the phrases have been recorded it is possible to play them

back through the built in loudspeaker.

This example shows how to play back “Message A” (Phrase0+A):

Ensure that the SD1+ is initialised and the display is showing

“

” (see page 4).

Press A and the display will show “ ”.

Pressing or will select message B, C or D.

After a 5 second delay the message is played.

Pressing ] at any point during the message will abort the

playback and return the unit to the “

” prompt.

Repeat for message B, C or D, as required.

1-4 / ENT

TO SEND

READY

SD1+

????

5 Seconds

PHRASE 0

PHRASE A

READY

]

This is Mr Smith,

at 10 The Strand,

East Fincham.

1 2 ... 11 12 13 14 15 16 17 18 19 20

Comments to this Manuals

No comments

Menvier Security SD1 User Manual Page 16

Comments to this Manuals

Related products and manuals for Door intercom systems Menvier Security SD1