Menvier Security TS900+ Specifications download pdf (Page 23)

Power-Up Checks

When the initial power-up checks have been

completed, check the following:

1. Switch off the 240V mains supply and measure

the DC voltage at each Node and remote

keypad and ensure the voltage is greater than

11V whilst the system is powered from its

standby battery.

2. Switch on the 240V mains supply and measure

the DC voltage between the mains earth

connection and AUX +12V. Then measure the

DC voltage between the mains earth

connection and AUX 0V. In both cases the

measurement should be 1V or less. If the

voltage is greater than 1V, the system has an

“Earth Fault” and all cables should be checked

for isolation to Earth.

3. Using a voltmeter measure the DC voltage

across the control panel PCB test points (V) and

calculate the system current consumption

(see page 7). Ensure that the reading is not

greater than 1.5A.

4. Repeat test (3) with the system in an alarm

condition and ensure that the reading is not

greater than 1.0A for the TS790 and 1.5A for the

TS900.

The TS790 & TS900 have an overload

protection circuit. If the power supply is

overloaded, the display will show: “PSU

OVERLOAD ! ! !” and sounder will sound.

NVM Defaults

Section Option Default

User Codes User 00 Engineer 1234

User 01 Master 5678

User 02 - 31 Not Used

Panel

Outputs

Panel Output 1 Walk Test

Panel Output 2 Courtesy Light

Panel Output 3 Switch 12V

Panel Output 4 Detector Reset

Panel Output 5 Code Accepted

Panel Output 6 Code Accepted

Panel Output 7 Code Accepted

Panel Output 8 Code Accepted

Digicom

Outputs

Digicom Output 1 Fire

Digicom Output 2 PA

Digicom Output 3 Alarm

Digicom Output 4 Set

Digicom Output 5 Engineer on Site

Digicom Output 6 Bell

Digicom Output 7 Tamper

Digicom Output 8 Second Alarm

Digi

Channels

Digi Channel 1 Fire

Digi Channel 2 PA

Digi Channel 3 Alarm

Digi Channel 4 Set

Digi Channel 5 Engineer on Site

Digi Channel 6 Bell

Digi Channel 7 Tamper

Digi Channel 8 Second Alarm

Node

Outputs

Node Output 1 Walk Test

Node Output 2 Courtesy Light

Node Output 3 Switch 12V

Node Output 4 Detector Reset

Node Output 5 Code Accepted

Node Output 6 Code Accepted

Node Output 7 Code Accepted

Node Output 8 Code Accepted

Node Output 9 Code Accepted

Node Output 10 Code Accepted

Circuits

Circuit 01 Final Exit

Circuit 02 Night (Access)

Circuit 03 - 06 Night

19

TS790 & TS900 Installation Manual System Installation

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 67 68

Comments to this Manuals

No comments