Menvier Security TS900+ Specifications download pdf (Page 36)

10 O/M's Mimic Circuits

When programmed as “Yes" the output

modules mimic circuit activations. When

programmed as ”No" output modules give

circuit alarm indication. (Default = Yes)

11 Do Battery Test

When programmed as "Yes" the control panel

battery and any monitored PSU batteries are

tested every hour and when exiting the

engineer's mode. When programmed as "No"

the control panel battery and any monitored

PSU batteries are not tested. (Default = No)

12 F.Exit is Night

When programmed as “Yes" final exit circuits

change to night circuits when the system is part

set. When programmed as ”No" final exit

circuits remain as final exit circuits when the

system is part set. (Default = No)

13 Audible Time Switch

When programmed as “Yes" the internal

sounder will activate when any of the time

switched outputs are active. When

programmed as ”No" the time switched

outputs remain silent. (Default = No)

14 Show Part Set Information (LED Keypads)

When programmed as “Yes" the display will

alternate between showing the time and

wards that are set when the system is part

set. When programmed as ”No" the display will

always show the time when the system is part

set. (Default = Yes)

15 Answer Phone Defeat

For use with the DC58M to allow downloading

to be carried out on telephone line with answer

phones. When programmed as "Yes" Answer

Phone Defeat is enabled. (Default = No)

16 Set with AC Off

When programmed as “Yes” the system can

be set with no mains power. When

programmed as “No” the system cannot be

set with no mains power. (Default = Yes)

17 Loud Chime Tones

When programmed as “Yes” the chime tones

are always at full volume. When programmed

as “No” the chime tones are at the level set by

VR1 on the main PCB. (Default = No)

18 Invert Output 1

When programmed as “Yes” panel output 1 is

inverted. When programmed as “No” panel

output 1 is normal. (Default = No)

19 Invert Digi Outputs

When programmed as “Yes"” the eight

digicom outputs on the control panel switch

from 0V to +12V when active (+ve applied).

When programmed as “No” the eight digicom

outputs on the control panel switch from +12V

to 0V when active (+ve removed). (Default =

No)

20 On-Line Keypad

When programmed as “Yes" the Menvier

Lineload On-Line Keypad feature is enabled.

When programmed as “No” the Menvier

Lineload On-Line Keypad feature is disabled.

(Default = Yes)

21 Restore Point ID

When programmed as "Yes" the Point ID restore

status is transmitted. When programmed as

"No" point ID restore is not transmitted. (Default

= Yes)

22 User Authorised

When programmed as “Yes” the Menvier

Lineload software can only write information to

the control panel after the user has authorised

remote communications. When programmed

as “No” the Menvier Lineload software can

write information to the control panel without

user authorisation. (Default = No)

23 Mimic Alarms and Faults

When programmed as “Yes” any outputs

programmed as the type "Circuit Alarm" will

activate when the relevant circuit is armed

and in alarm or in a fault condition. When

programmed as “No” any outputs

programmed as the type "Circuit Alarm" will

activate when the relevant circuit is in alarm,

whether the circuit is armed or disarmed.

(Default = No)

32

Engineer’s Menu 1 TS790 & TS900 Installation Manual

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 67 68

Comments to this Manuals

No comments