Menvier Security TS900+ Specifications download pdf (Page 57)

Domestic Part-Set Application Example

The TS790/900 is very flexible in the way that the

system can be part-set. The system may be

part-set by using the part-set buttons on the

remote keypad or by using a part-set passcode.

The first application example shows how to use the

part-set buttons to set different areas of a 3

bedroom house. The second example will show

how to achieve the same results using a different

approach. Try both and use the one you are

happier with.

Defining Part-Set buttons to Omit a Ward

This is probably the easier method of configuring

the part-set groups as you can easily take the

information from a table and translate it directly

into the ward programming details.

Using the drawing of a typical 3 bedroom house,

the following part-set arrangements are required:

Part Set A Downstairs perimeter detection

armed and downstairs internal

detection armed.

Part Set B Downstairs perimeter detection

armed, downstairs internal

detection armed and bedroom

2 armed.

Part Set C Downstairs perimeter detection

armed.

1. First create a table listing the circuits that are

required to be Armed (A) and Omitted (O) for

each part-set requirement:

Circuit Location P-Set A P-Set B P-Set C

01 Front Door A A A

02 Smoke Detector A A A

03 Hall door to garage A A A

04 Garage door A A A

05 Garage back door A A A

06 Kitchen door A A A

07 Dinning room PIR A A O

08 Lounge PIR A A O

09 Bedroom 2 PIR O A O

10 Landing PIR O O O

2. From the above Table create a second Table

that details the ward assignment for each

circuit. The rules for generating the second

table are as follows:

(a) Circuits that are armed in all three part set

groups can be considered as being

assigned to the “System Ward” and are

NOT assigned to wards A, B or C.

(b) Circuits that are omitted are assigned to

their respective ward, e.g., circuit 09 is

omitted for part set A and C, therefore it

must be assigned to wards A and C.

3. The completed Table should look like the table

shown below. Circuits with no ticks are

assigned to the System Ward:

Circuit Location Ward A Ward B Ward C

01 Front Door

02 Smoke Detector

03 Hall door to garage

04 Garage door

05 Garage back door

06 Kitchen door

07 Dinning room PIR

08 Lounge PIR

09 Bedroom 2 PIR

10 Landing PIR

4. From the above Table assign circuits 01-10 to

their relevant wards (see “Configure Wards” on

page 37).

5. Program the Part set groups (see “Part set

Groups”, on page 43). This ensures that when

the user selects button A, B or C the system

omits the correct ward. When using this

method, the part set groups

programmed as follows:

Part Set Group A = [S BC] (Omits Ward A)

Part Set Group B = [SA C] (Omits Ward B)

Part Set Group C = [SAB ] (Omits Ward C)

When defining part set groups it is

important to remember that circuits

assigned to more than one ward will only

be armed when

the wards its

assigned to are set. e.g., the Landing PIR

will only be armed when ward A, B and C

are set (i.e., Full set in our example).

TS790 & TS900 Installation Manual Appendices

1 2 ... 52 53 54 55 56 57 58 59 60 61 62 ... 67 68

Comments to this Manuals

No comments

Menvier Security TS900+ Specifications Page 57

Comments to this Manuals

Related products and manuals for Security access control systems Menvier Security TS900+