Menvier Security SD1 Instruction Manual download pdf (Page 11)

Installing a Remote Keypad

Ensurethatthemainsandbatterypowerhasbeen

disconnected and proceed as follows:

1. Connecteach core ofthe 6-core cableto the

interfaceterminals"LEDCBA"(makeanoteof

the colours used for each connection).

2. Passtheyellow flying-lead behind thePCBand

connect it to the [L/S-] terminal.

3. Plug the Interface board into the interface

socket as shown below.

4. Separate the remote keypad cover and base

by using a screwdriver to push two of the clips

(top or bottom) inwards from the cover

retaining slots. Then lift the cover assembly,

noting that the circuit board is connected to

the under side of the cover.

5. Hold the remote keypad base in position

(keyhole to the top) and mark the three

securing holes, drill and plug the wall as

required. Pass the 6-core cable into the base

via the cable entry points as appropriate and

secure the base to the wall.

6. Connecteach core ofthe 6-core cableto the

remotekeypadterminals"LABCDE",ensuring

that the connections through to the control

panel are A to A, B to B, etc. If more remote

keypads are to be fitted, they may be

connected in a star or daisy chain

configuration (providing the cable length to

the last or furthest remote keypad does not

exceed 50 metres).

7. Carefully reattach the front cover assembly to

the remote keypad base ensuring that all

cables are clear of the tamper switch spring

andthecoverissecurelyclippedtothebase.

External Sounder Connections

The following terminals have been provided to

allow connections to an external sounder:

H/O - This is used to provide a permanent -ve

holdofftoexternalsounders,strobesetc.

H/O + This is used to provide a permanent +ve

hold off to external sounders, strobes etc.

Itisprotectedbya1Ampfuse(Bell12V).

TMP - This is the negative tamper return

connection from the external sounder. If

an external sounder is not fitted this input

must be linked to [H/O -].

STB - This is the strobe output which switches to

0Vonalarm.Theoutputisratedat500mA

and should be connected to -ve strobe

trigger input on the external sounder.

TRG - This is the external sounder trigger output

which is rated at 500mA. This output can

be programmed for SAB or SCB

operation, as follows:

SAB: TRG - will switch to 0V on alarm and

will provide a maximum of 500mA.

SCB: TRG - will provide a negative hold

off (500mA), which is removed on alarm.

11

TS400/TS410 Installation Instructions System Installation

InterfacePCB

Flying-lead

connectedtoL/S-

Flying-lead

L/S

Figure 7 Remote Interface Connections

Typical

External Sounder

Control

Panel

H/O +

12V +

H/O -

0V

Tamper In

TMP -

STB -

Tamper Out

TRG -

Strobe +ve

Strobe -ve

Trigger -ve

Figure 8 External Sounder Connections

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 23 24

Comments to this Manuals

No comments