Menvier Security SD1 Instruction Manual download pdf (Page 4)

Planning The Installation

General

TheTS400 and TS410are flexible systems,but care

must be taken in planning the installation to

provide maximum protection with minimum

effort.

Survey the household and determine where each

security device is to be fitted. Wherever possible,

trytoconcealwiring(e.g.,intheloft,undercarpets

orfloorboardsandinsidecupboards).Committhe

system design to paper for future reference.

Cable Routing

When installing cables, the following should be

noted:

Ensure that all cables are kept clear of mains

supply cables, telephone cables, cables

supplying bells or sounders and any cables

likely to induce electrical noise (R.F.) into the

system.

l Screened cable may prove necessary if

cablesare run adjacent tocables which carry

R.F. (electrical noise) or are switching high

current loads.

The mains power supply cable to the system

must be connected to an un-switched fused

spurthatcannot be accidentally switchedoff.

The mains cable must enter the control panel

housing via its own cable entry point.

TS400 Control Panel

The TS400 control panel should be located in a

position where it has easy access for the users to

set and unset the system. It should by mounted at

a level where it is easy to operate the keypad and

read the indicator LEDs. The provision for

connecting to a permanent mains supply must

also be considered.

Whenoperatingthesystemitshouldbepossibleto

hear the exit and entry tones throughout the entry

& exit route and outside the final exit door. If the

control panel is positioned a long way from the

final exit door, it may be necessary to fit an

extension loudspeaker.

TS410 Control Panel

TheTS410controlpanel is blind panel andas such

it can positioned out of view, normally in a

cupboard under the stairs. The provision for

connecting to a permanent mains supply must

also be considered.

Whenoperatingthesystemitshouldbepossibleto

hear the exit and entry tones throughout the entry

& exit route and outside the final exit door. If the

remote keypad is located a long way from the

final exit door, it may be necessary to fit an

extension loudspeaker.

External Sounder

The external sounder should be mounted as high

as possible so that it is visible and out of reach to

potential intruders. A six-core cable is required for

connection to the sounder which should enter

directly through the wall and into the sounder via

thecableentries in the back plate.However,ifthe

cable is run over the surface to the sounder then it

should be protected (e.g., the cable may be run

in aluminium conduit).

Remote Keypad

If required, up to four remote keypads may be

connected to the system to allow remote

operationof the system.Theremotekeypadhas 8

LED indicators and an internal sounder to indicate

all system tones. Remote keypads require a

six-core cable for connection.

Planning The Installation TS400/TS410 Installation Instructions

1 2 3 4 5 6 7 8 9 ... 23 24

Comments to this Manuals

No comments

Menvier Security SD1 Instruction Manual Page 4

Comments to this Manuals