Menvier Security SD1 Instruction Manual download pdf (Page 19)

Testing & Fault Finding

Testing the System

Once the system has been installed and fully

programmed it can be tested. Before performing

any tests it is advisable to warn your neighbours of

any tests that involve using the external sounder.

1. PerformaWALKTESTtoensurethatallzonesare

operating correctly.

2. Perform a BELL TEST to ensure that the external

sounder and strobe is operating correctly (See

"User Operating Instructions" for details on BELL

TEST).

3. Set the alarm system. Open a door or activate

a detector to create an alarm.

4. Unset the system to silence the internal and

external sounder.

5. Ensurethe correct zoneLED is lit,then enter the

passcode again to clear the indications.

Installationandchecks are now complete,ifthere

are any problems in your installation refer to the

section on Fault Finding.

Fault Finding

If you have carefully followed the installation and

wiring instructions and carried out the various

checks correctly, your security system will now be

fully operational.

However if the system is not operating correctly

when you have completed the installation, or it

has developed a fault after a period of trouble

free operation, the Fault Finding Charts will help

you identify and clear the fault.

Before using the fault finding charts refer to the

following notes:

When removing covers from the control

panel,external sounder or detectors youmust

remember to first enter the four digit engineer

code into the control panel.

When all tests are complete, remember to

replace all covers etc.

A battery operated circuit tester available

from most hardware and DIY stores, or a

simple battery bulb and length of wire, will

assist in checking the continuity of circuit

wiring, if necessary.

TS400/TS410 Installation Instructions Testing & Fault Finding

1 2 ... 14 15 16 17 18 19 20 21 22 23 24

Comments to this Manuals

No comments

Menvier Security SD1 Instruction Manual Page 19

Comments to this Manuals