Menvier Security SD1 Instruction Manual download pdf (Page 18)

Keyswitch Operation

The operation of the keyswitch (zone 3) can be

programmed as either:

AWAY: When keyswitch zone is opened the exit

procedureforAWAYsetwillstartandthesystemwill

attempt to full set. When the zone is closed the

system will unset.

HOME: When the key switch zone is opened the

exit timer will start and when the timer has expired

thesystemwillbepartset.Whenthezoneisclosed

the system will unset.

RST- Output

The operation of the [RST-] output can be

programmed as either:

SW 12V: This can be connected to the "Latch"

input on latching detection devices.

Detector Reset: Thiscanbeusedasthe0V

connection to detectors that require the power to

be removed to reset them (such as smoke

detectors and vibration sensors).

➤ To program the system options proceed as

follows:

1. Ensure that the engineer’s menu is selected,

then press [9] to select system options.

2. Press keys [1] to [6] to toggle the zone LEDs on

or off. The system options will be set according

to the status of the relevant zone LED as shown

below:

Zone LED LED On LED Off

Zone 1 Bell output is an

SAB

Bell output is an

SCB

Zone 2 System is set by

Final Exit

System is set by

Timed exit

Zone 3 System is reset

by the Engineer

System is reset

by the User

Zone 4 System re-arms

three times

System re-arms

once

Zone 5 Keyswitch =

Home set

Keyswitch =

Away set

Final Exit RST output is

SW12V

RST output is

Detector Reset

3. When completed, press [0] to accept, a high

pitched acceptance tone will be heard.

Returning to the Unset Mode

Oncealltheengineerprogrammingiscompleted

the system can be returned to the unset mode by

pressing the [0] key. The user passcodes and

"HOME" set configuration must also be

programmed,seethe"UserGuide"forfulldetails.

Full Setting the System (AWAY)

The engineer can use his passcode to full set the

system as follows:

1. Ensure that the engineer’s menu is selected,

then press [AWAY] to full set the system.

2. The exit tone will start and the Final Exit LED will

flash.

3. Whentheexittonestops,thesystemisfullset.

Part-Setting the System (HOME)

The engineer can use his passcode to part set the

system as follows:

1. Ensure that the engineer’s menu is selected,

then press [HOME] to part set the system.

2. The Final Exit LED will flash (HOME set is always

silent and timed).

3. When the high pitched tone is heard the

system is part set.

Unsetting the System

The engineer can only use his passcode to unset

the system when the system is set or part set using

the engineer passcode (i.e., if the system is set by

the user the engineer passcode will NOT unset the

system).

1. Enter via the prescribed entry route.

2. Theentrytone will startandtheFinal Exit LEDwill

flash.

3. Entertheengineer’spasscode(e.g.,1234).

4. The entry tone will stop and the unset LED will

light.

Programming TS400/TS410 Installation Instructions

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 24

Comments to this Manuals

No comments

Menvier Security SD1 Instruction Manual Page 18

Comments to this Manuals